COMPOSITE DESIGN SP2 STANDARD POWER PANEL + B&C OVER VOLT KIT +ACS IGN SWITCH For Sale

COMPOSITE DESIGN SP2 STANDARD POWER PANEL + B&C OVER VOLT KIT +ACS IGN SWITCH
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.


Buy Now

COMPOSITE DESIGN SP2 STANDARD POWER PANEL + B&C OVER VOLT KIT +ACS IGN SWITCH:
$513.50

COMPOSITE DESIGN SP-2 STANDARD POWER PANEL + 4 SPARE POTTER & BRUMFIELD RESETTABLE CIRCUIT BREAKERS + ACS A510-2 IGNITION SWITCH + B&C OVM-14 OVER VOLTAGE PROTECTION KIT
Very good condition, each circuit individually bench tested. COMPOSITE DESIGN SP-2 STANDARD POWER PANEL SBP02R1US made, Composite Design power panels are self-contained power distribution assemblies that replace most of the components found in an aircraft electrical service bus. The panel includes bus bars, switches,relays, circuit breakers and terminal strips. PC boards are specially designed with very heavy over plating that will easily carry excessive loads. All wire is Mil Spec 22759, all components are selected for proper DC ratings. User connections are robust screw mounted ring terminals.
The SP-2 Standard Power Panel is aversatile and robust power system made to compliment modern avionics and instrumentation. Rated at 80A, the panel includes master and alternator switches, RF protection, and 18 resettable breaker protected circuits of which 8 have individual switches. Each circuit includes individual ground connection.
Two spare P&B resettable 10A and two 6A breakers allow for maximum versatility and panel can be easily reconfigured for specific aircraftrequirements.
Complete with wiring diagrams, schematics and panel template.
  • Dimensions: 2.25”H x 13.00”W x 7.75”D. ( 57x320x197mm)
  • Weight: approx. 2.5pds (1.2kg)
  • Capacity:17.5 V max. at 80A
  • Switches:
    Master
    Alternator Field
    Radio Master
    Landing Light
    Strobe Lights
    Nav Lights
    Fuel Pump
    Pitot Heat
  • Circuit Breakers
  • Landing Light 10A
    NavLights 10A
    Strobes 10A
    Fuel Pump 10A
    Pitot Heat 15A
    Alt Field 5A
    Start 3A
    Flaps 5A
    Trim 3A
    Radio 1 5A
    Radio 2 5A
    Transponder 3A
    GPS 3A
    MFD Panel 5A
    Auto pilot 5A
    Fan Inst Lights 3A
    Spare 10A


B&C OVM-14 PM/OV FILTER & OVER VOLTAGE PROTECTION KIT
This kit provides crucial over-voltage protection to permanent magnet alternators (SD-8, 200G, SK-10, and LOM-10) and others rated at 15 amps or below including Rotax 912/914. Alarm can be wired to warning light (LED light included) or most glass panel systems to warn if the crowbar over-voltage protection module is tripped (or when the alternator switch is left off), and a filter capacitor to reduce radio noise and enhance voltage regulation. Simple wiring allows quick retrofit or new installation.

IncludesB&C crowbar overvoltage module OVM-14. (14V)Alternator disconnect contactor Tyco S701-1Mallory 22,000 uF Capacitor 658-0903-352LED warning lightWiring diagramACS A510-2 IGNITION SWITCH
High quality FAA PMA approvedmagneto and ignition switch are used in many aircraft.
OFF RIGHT LEFT BOTH START operation.
The switch housing is machined from billet aluminum which makes this switch 25% lighter. They provide “ON” and “OFF” electrical control of both magnetos on single engine aircraft. The key-operated switches mount from the rear of the panel in a 7/8” dia hole. Includes starter key position.

Supplied w/switch plate, machined aluminum mounting bezel, key and wiring diagram.
Shipped world wide via tracked EMS Express Post
Buy with confidence with money back guarantee from a 100% positive rated member.




Buy Now

Powered by WordPress. Designed by WooThemes