Vintage CATTO Aircraft Wood 3 Blade Propeller Experimental Amateur Built EAB For Sale
Vintage CATTO Aircraft Wood 3 Blade Propeller Experimental Amateur Built EAB:
Vintage CATTO Aircraft Wood 3 Blade Propeller Experimental Amateur Built EAB
There are61 photosof the item below.
---The photos load incrementally below depending on your connection, please allow a few seconds for the photos to appear
--- Unknown vintage, besides the Catto decals on each blade the only other marking is 50 26 stamped into the wood. Weight is 4 lbs 2 ounces.The distance between the end of each blade to the on-center/middle of the center mount hole is 25". I don't know the wood type. This is used but I don't see damage, the laminations are all good and I don't see separations. There is some finish wear including scratches, indents, nicks etc. I don't know what the original application was (someone suggested to me that this might be a push or rear type prop). With the propeller resting on a flat surface on 2 blade ends, the distance between the top edge of vertical blade to the flat rest surface is 38". The distance between the ends of the two blades resting on the flat surface is 44" (or close). The width of the tips is 2" (measured down before the edge rounding). The thickness in the center of the prop is 1.5". The on center distance across two of the center mount holes is 3-1/8" (measured across the center hole). The center hole diameter is 1". The diameter of the 4 smaller hole mounts is 5/16" or close. For shipping I will custom create a container from double faced sheet foam surrounded by a box (in the same way a valuable painting etc would be packed).
--- See photos for condition details.
--- Will be well packed
--- See shipping options above
--- Payment expected within3 daysof purchase (contact me if you need more time).
--- The item description is guaranteed to be accurate but all items are sold as-is unless otherwise stated.
---I don't have a way to arrange for a local pick-up of this item, I'm sorry for the inconvenience